• If Manual/auto switch: ON is selected in Advanced, you must answer an incoming call by•
picking up the handset within the time specified in RX start time. Otherwise the printer will
switch to fax reception.
When Fax only mode is selected:
• When the call is a fax:•
The printer will receive the fax automatically.
Note
• If a telephone is connected to the printer, the telephone will ring when a call incomes.•
• You can change the number of times to ring the telephone with Ring count in Advanced.•
When DRPD or Network switch is selected:
• When the call is a fax:•
The telephone will ring when a call incomes.
The printer will receive the fax automatically when the fax ring pattern is detected.
Note
• You can change the number of times to ring the telephone.•
Advanced Settings of Receive Mode
• When the call is a voice call:•
The telephone will ring when a call incomes.
When the printer does not detect the fax ring pattern, the telephone will continue ringing.
515
To Next Page
Loading...
Need help?
General