Error Regarding Power Cord Being Unplugged Is Displayed (Windows)
The printer may have been unplugged while it was on.
Check the error message displayed on the computer and click OK.
The printer starts printing.
Refer to Turning the Printer On and Off for the correct way to turn the power off.
Writing Error/Output Error/Communication Error (Windows)
Check 1
If the printer is not turn on, make sure it is connected to the power supply and
turn it on.
Check 2
Make sure printer is properly connected to computer.
If you are using a USB cable, make sure it is securely connected to both the printer and the computer. When
the USB cable is securely plugged in, check the following:
•
If you are using a relay device such as a USB hub, disconnect it, connect the printer directly to the
computer, and retry the printing. If printing starts normally, there is a problem with the relay device.
Contact the vendor of the relay device.
•
There could also be a problem with the USB cable. Replace the USB cable and retry the printing.
If you use the printer over a LAN, make sure the printer is correctly set up for network use.
Check 3
Make sure MP Drivers are installed correctly.
Refer to
Updating the Driver to uninstall unnecessary drivers and install the latest drivers.
Check 4
When printer is connected to your computer with a USB cable, check device
status from your computer.
Follow the procedure below to check the device status.
1.
Select Control Panel > Hardware and Sound > Device Manager.
1.
Note
•
If the User Account Control screen is displayed, select Yes.
2. Open USB Printing Support Properties.2.
Double-click Universal Serial Bus controllers and USB Printing Support.
Note
• If the USB Printing Support Properties screen is not displayed, make sure the printer is•
correctly connected to the computer.
Check 2
Make sure printer is properly connected to computer.
3.
Click General tab and check for a device problem.
3.
692
To Next Page
Loading...
Need help?
General