79
ENG
UltraCella +0300083EN - rel. 1.5 - 07.02.2015
11. SOFTWARE RELEASE
11.1 Software release table
Manual
release
Availability
date
Functions UltraCella
Software
release
Notes
1.1 28/02/2014 Basic cold room management: compressor, defrost, evaporator fans, light,
2xAUX relays
1.1 UltraCella single digit display
Single digit display management
Commissioning UltraCella through both built-in LED display and pGD1
UltraCella Service
Commissioning through wizard on pGD1
Upload/Download parameters via USB key
Defrost schedule by RTC
HACCP alarms
Maximum and minimum temperature recording
Diagnosis: I/O status visualization
Second step compressor with automatic rotation
Evaporator fans in PWM mode (on/off ) with compressor off
Auxiliary evaporator management
Smart light management by door switch
Bowl heater activation
Condenser fan activation by temperature
Pump down management
Humidity probe reading
Pre-charged confi gurations (recipes)
Software update through pGD1
1.3 30/06/2014 Double digit display management 1.2 UltraCella double digit display (software
release 1.2) availability in production:
11/04/2014
Data logging function (one temperature)
Humidity ON/OFF output
Serial connection UltraCella - EVD EVO (only "start command")
Service menu on pGD1 (diagnosis)
Navigation improvements on both LED and pGD1 1.3 UltraCella software 1.3 availability in
production: 30/06/2014
Added alarm indication on USB functions (in case of bad working)
Commissioning EVD EVO via UltraCella
Defrost by dI (fi xed interval time) enable with RTC defrost set too
Limit and default parameter setting change (H0, /t2, dd, Fd)
0…10V output for variable speed evaporator fans
"Bugfi xing:
Input B5 Humidity reading
High/low temp. alarm delay
EVD communication in manual OFF status"
1.4 UltraCella software 1.4 availability in
production: 03/11/2014
1.5 30/01/2015 3PH expansion module management (one to one) 1.5 UltraCella software 1.5 availability in
production: 22/12/2014
Data logging: 2 selectable temperatures, variable sampling time
Log of stored alarms
BMS serial line: Modbus / Carel protocols selectable
Software update by built-in LED display
Addition of pGD texts in German and French
New default /A2=1 (defrost probe confi gured in B2)
New default settings for EVD module (push from UltraCella)
Door switch disabling (new question in wizard and new parameter A3)
Tab. 11.a