now before you install the battery pack or at another time. See more details about these
cards in Chapter 2, Hardware Components, Micro SD Cards and Chapter 8, 3G Data
Modem, Install the Mini SIM Card.
3. Place the Li-Ion battery pack in the compartment. Make sure the + and - symbols on the
battery pack label align with the symbols inside the compartment.
n
4. Replace the door and tighten the screws.
5. Plug the AC wall power charger that came with the Surveyor2 into a wall socket. Plug the
other end into the DC power jack on the Surveyor2. The red LED on the keyboard blinks
when the battery pack is charging.
ATTACH THE HAND STRAP AND STYLUS TETHER
A hand strap, capacitive stylus and tether are included with the handheld.
Note: A stylus is not required to use the touchscreen. The optimal way to make selections is by
finger touch.
If the hand strap was not attached at the factory or you want to move it to the other side, follow
the diagram below to attach it to the right or left side of the handheld:
Line up the + and – symbols
on the case and the battery
To Next Page
Loading...
Need help?
General
