This cell modem is compliant with FCC regulations when operated within the temperature range
of -30°C to +50°C. Do not operate the cell modem outside of this temperature range.
INDUSTRY CANADA
In compliance with Industry Canada rules, the following statement must appear on the device or
in the user documentation:
This Class B digital apparatus complies with Canadian ICES-003.
RADIO FREQUENCY SAFETY
This device has been evaluated for use in close proximity to the body. Use only accessories
approved by Juniper Systems. The use of third party accessories may not comply with FCC and
international RF exposure requirements. To comply with FCC and other national RF exposure
requirements do not co-locate this device with other transmitters.
This device operates in compliance with the FCC radio frequency exposure limits for an
uncontrolled environment. Users must follow instructions provided in the user documentation to
satisfy compliance with FCC radio frequency exposure requirements.
There cannot be any alteration to the authorized antenna system.
CE MARKING (EUROPEAN UNION)
Products bearing the CE marking comply with the
2004/108/EC (EMC Directive), 1999/5/EC (R&TTE Directive), 2006/95/EC (Low Voltage Directive)
issued by the Commission of the European Community.
CE compliance of this device is valid only if powered with/by a CE-marked wall charger provided
by the manufacturer. Cables connecting to the USB host port must use a ferrite core/bead on the
cable. The ferrite core must be placed on the cable near the end that connects to the Surveyor2.
This device has been evaluated using the following standards to demonstrate compliance with
applicable directives:
EN 60950-1:2006
IEC 62209-2 Ed. 1.0
IEEE Std. C95.1-1999
EN 301 489-1 V1.8.1
EN 301 489-7 V1.3.1
EN 301 489-17 V2.1.1
To Next Page
