One end of the stylus tether is attached to the stylus. To attach the tether to the handheld, follow
these steps:
1. Push the free tether loop through one of the tether attachment points on the back of the
handheld towards the top.
Insert the stylus with the attached tether through this loop and tighten the loop.
2. Place the stylus into the holder on the hand strap.
PERFORM SET UP
1. Press the power key . The handheld powers on and begins the startup process. A splash
screen is shown that includes a progress indicator at the bottom.
2. A Microsoft® Windows Embedded Handheld screen is shown.
3. The Update Time screen appears. Adjust the time zone, date and time if necessary and tap
OK.
4. You might be asked to restart the handheld to complete installation.
5. The Home screen appears (the layout varies by model).
To Next Page
Loading...
Need help?
General
