3. When the screen turns black, press and hold the power key again until the bios screen is
shown.
4. Move the top slider on the screen to the right to set or clear factory defaults (this clean
boots the handheld).
5. Tap Exit. The boot process continues. The Update Time screen is shown. Update the
information as needed and press OK.
SUBDUED LIGHTING (TACTICAL) MODE
In some environments subdued lighting is preferred. The display backlight, LEDs,
and keyboard illumination can be subdued during the startup process and normal
operation.
SET UP DURING A RESET
1. Save open files and close running programs on the Surveyor2. Press and hold the power
key until the Power Key menu appears. Tap Reset.
2. When the screen turns black, press and hold the power key again. The bios screen is
shown.
3. Move the slider on the screen to the right to turn the tactical mode on.
4. Tap Exit. The boot process continues.
To restore the handheld to default lighting, follow the same steps outlined above.
ADJUST BRIGHTNESS USING THE KEYBOARD
You can adjust the display and keyboard brightness any time from the keyboard.
For the display, brightness up is + and brightness down is + .
For the keyboard, brightness up is + forward tab and brightness down is + back tab .
ADJUST THE BACKLIGHT CONTROL PANEL
You can also subdue the keyboard and display brightness through the Backlight control panel.
Press Start > Settings > System > Backlight and then External Power or Battery Power from the
horizontal scrolling menu near the top of the screen. Adjust the sliders as needed for both power
sources. Changes affect all operations.
To Next Page
Loading...
Need help?
General
