3G DATA MODEM
The 3G data modem is included in the Surveyor2 Standard Cell and Surveyor2 Geo Cell models,
adding Wide Area Network data modem capability. The modem is installed at the factory.
The modem is a cellular data modem, type GSM/UMTS. It is five band modem compatible. The
modem operates in different modes, depending on the wireless provider and the signal strength.
Data speeds vary anywhere from 10 or 20 Kbps when using GPRS to over 1 Mbps when using
HSDPA.
SET UP A DATA ACCOUNT WITH A WIRELESS PROVIDER
Contact a wireless provider to set up data service for the cellular data modem and obtain an
account and mini SIM card (purchased separately). You need to provide the following information
when setting up an account:
1. Billing Information and business ID, such as your Federal Tax I.D. or VAT number.
2. The wireless services required. Specify that you need data service only. You do not need
voice or messaging services.
3. You may be asked for the modem’s IMEI number, which can be found here: Start >
Settings > System > System Information > 3G Modem with the modem powered on.
4. You may be asked to provide the modem’s model number. This number allows the carrier
to verify this modem as one of its approved models. If asked for this by the carrier, it is a
Juniper Systems Allegro2.
INSTALL THE SIM CARD
To insert or remove a SIM card follow these steps:
1. Power off the handheld.
2. The mini SIM card slot is located in the battery compartment. Loosen the screws to the
door and remove it.
CAUTION: Do not use a micro SIM adapter. The adapter can get stuck and damage the slot.
3. Remove the battery pack.
CAUTION: The Surveyor2 is not sealed against water and dust when the battery door is not
installed.
4. An image on the battery compartment label shows the correct location and orientation
for the mini SIM card. Pull out the SIM card tray. Place the card onto the tray and push the
tray in until it catches.
To Next Page
Loading...
Need help?
General
