Use only wall chargers intended for the Surveyor2. Using any other external power source can
damage your product and void your warranty.
CERTIFICATIONS AND STANDARDS
FCC - UNITED STATES
In compliance with the FCC rules 47 CFR 15.19(a)(3), the statements that follow must appear on
the device or in the user documentation.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. The device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
In compliance with the FCC rules, 47 CFR 15.105(b), the user must be notified that this equipment
has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
In compliance with the FCC rules, 47 CFR 15.21, the user must be notified that changes or
modifications to the Rugged Handheld that are not expressly approved by the manufacturer could
void the user’s authority to operate the equipment.
Only approved accessories may be used with this equipment. In general, all cables must be high
quality, shielded, correctly terminated, and normally restricted to two meters in length. Wall
chargers approved for this product employ special provisions to avoid radio interference and
should not be altered or substituted.
This device must not be co-located or operating in conjunction with any other antenna or
transmitter.
To Next Page
Loading...
Need help?
General
