Cedar Summit F25720 - Slide Wall Assembly

1 x End Slide Panel 1-1/4 x 37 x 92”
1 x Narrow Panel Back 1-1/4 x 21-1/2 x 92”
1 x Narrow Front Panel 1-1/4 x 21-1/2 x 92”
Wood Parts
040
Step 4: Slide Wall Assembly
A: Place (041) Narrow Panel Back against the left side of (040) End Slide Panel noticing panel orientation. The
tops and bottoms of the panels should be ush and panels square. Pre-drill with a 3/16” drill bit, then fasten
(041) Narrow Panel Back to (040) End Slide Panel with 4 (WL5) 1/4 x 2-1/2” Wafer Lags. (g. 4.1 and 4.2)
B: Place (042) Narrow Front Panel against the right side of (040) End Slide Panel noticing panel orientation.
The tops and bottoms of the panels should be ush and panels square. Pre-drill with a 3/16” drill bit, then fasten
(040) Slide End Panel to (042) Narrow Front Panel with 4 (WL5) 1/4 x 2-1/2” Wafer Lags. (g. 4.1 and 4.3)
Fig. 4.2
Fig. 4.1
Hardware
8 x 1/4 x 2-1/2” Wafer Lag
WL5
041
042
Notice(041)Narrow
Back Panel overlaps
(040)SlideEndPanel
Fig. 4.3
WL5
A
B
A
B
A
B
Flush
040
041
WL5
042
040
Notice(040)SlideEnd
Paneloverlaps(042)
Narrow Front Panel
Flush
040
Flush
24 europecustomerservice@kidkraft.com