Cedar Summit F25720 - Page 28

A
Hardware
2 x Tie 1 x 3 x 24-1/2”
Wood Parts
062
Step 6: Join Swing and Slide Wall Assemblies
Part 3
E: From inside the assembly, place 1 (062) Tie centred between (041) Narrow Panel Back and (052) Wall Panel
Back so it is ush to the tops of the panels and the angled ends face out then attach with 2 (H10) 1/4 x 2-1/4” Hex
Bolts (with lock washer, at washer and t-nut) and 2 (S11) #8 x 2” Wood Screws. (g. 6.6 and 6.7)
F: Repeat Step E to attach 1 (062) Tie to (042) Narrow Front Panel and (051) Panel Front Wall. (g. 6.6 and 6.7)
Inside View
Fig. 6.7
4x 1/4x2-1/4”HexBolt(with1/4”lockwasher,1/4”atwasherand1/4”t-nut)
4 x #8 x 2” Wood Screw
S11
H10
Front Wall
052
041
Back Wall
Fig. 6.6
H10
Flush
Angled ends
to the outside
062
041
1/4” Flat
Washer
1/4” Lock
Washer
1/4” T-Nut
S11
A
28 europecustomerservice@kidkraft.com