Cessna 150M - Elevator Trim Tab Actuator Assembly; Elevator Trim Tab Travel Adjustment

A
• FWD
1. Actuator Assembly
2. Nut
3. Chain Guard
4.
5.
6.
7.
8.
Screw
Sprocket
Bearing
Collar
Groov-Pin
Figure 9 -2. Elevator Trim Tab Actuator Assembly
1. With elevators in neutral, set trim tab to neutral (streamlined).
2. Position stop block (3) against turnbuckle and secure to cable B.
15
9.
10.
11.
12.
13.
14.
15.
16.
Screw
Groov-Pin
Retaining Ring
Housing
O-Ring
Bearing
Threaded Rod End
Bearing
3. Place inclinometer on trim tab and run tab to DOWN TRAVEL limit listed in Section 1.
4. Position stop block (2) against stop block (3) and secure to cable A.
5.
Run trim tab to UP TRAVEL limit listed in Section 1, place stop block (1) against
stop block (2) and secure to cable B.
Figure 9-3. Elevator Trim Tab Travel Adjustment
Change 3
•
I
9-5