Cessna 150M - Page 284

NOTES
1. Used on exterior airframe and main gear fairings, also nose gear fairing beginning with 1970 Models.
2. Used on nose gear fairing thru 1969 Models.
3. Used to paint inside door facing beginning with aircraft 15074710, A1500421,
F15001014
and FA1500212.
4. Used with acrylic lacquer or lacquer on aluminum surfaces.
5. Used with epoxy paint.
6. Used to thin lacquer paint and for burndown.
7.
Used to thin acrylic paint and for burndown.
8.
Used with epoxy (Du Pont).
9. Used with epoxy (Enmar).
10. Used to clean aircraft exterior prior to priming.
19 -2 Change 3
NOTE
Do not
paint Pitot Tube, Gas Caps or Antenna covers
which were not painted at the factory.
I
When stripping paint from the aircraft, avoid stripper coming
in contact with ABS parts. These areas should be cleaned with
soap and water and/or Naphtha. Do not use strong solvents
such as Xylol, Toluol, or Lacquer Thinners. Once clean, ex-
terior ABS parts are ready for the acrylic laquer topcoat. Do
Not
wash prime ABS parts.