Printing Data
Vibrex 2000 and Vibrex 2000 Plus User Guide 25
3. The printout of the current settings is followed by the prompt:
Continue? : Push ‘On-line SW’
Write? : Push ‘Paper feed SW’
• To change the DIP SW settings, push the
ONLINE button, and go
to step 4.
• To leave the DIP SW settings unchanged, push the
FEED button,
and go to step 6.
4. Dip SW1 is printed, prompting the input of new settings for switch
No. 1 through 8 of DIP SW-1.
NOTE: Always input either ON or OFF for every setting in order for
switch No. 1 through 8 because the DIP SW set mode cannot be
canceled once it is initiated.
• ON can be set by pushing the
ONLINE button once and OFF by
pushing the
FEED button once.
• The setting is printed out after the
ONLINE or FEED button is
pushed to confirm the new setting.
5. As soon as switch No. 8 is set, the printer once again prompts with
Continue? or Write?, and stops. Repeat step 3 for DIP SW-2
and -3.
NOTE: The on-line lamp lights when the
ONLINE
button is pressed
and the off-line lamp when the
FEED
button is pressed to allow
confirmation of the button operation.
6. After the
FEED button is pushed, the on-line and off-line lamps
alternately blink, and the new settings are written to memory. When
the printer finishes writing everything to memory, the DIP SW
setting complete message is printed out, and the printer
returns to the on-line mode.
7. As soon as switch No. 8 of DIP SW-3 is set, the printer writes the
settings to memory regardless of which button (
ONLINE or FEED) is
pushed. See page 26 for an example of the settings printout.
CAUTION: Never turn the printer off while it is writing the new
settings to memory. Always wait until the DIP SW setting
complete message is printed, then turn the power off.
To Next Page
Loading...
Need help?
General
