Revision History
The following lists the additions, deletions and modifications in this manual at each revision.
Modify the description of section “Protection Features” in the chapter
of “Operation Overview.”
Modify the following sections in the chapter of “Local Operation”:
– “Setting Dynamic Load Frequency Sweep Value
rate.
– “Setup of Current Interrupt Function” for setting Load On Time.
– “Setup of Program Sequences Function” for selecting range.
Add the following chapters:
– “Remote Operation”
Correct the errors in the manual.
Add the following sections:
− “Load ALL RUN” and “Sine Wave Dynamic” in the chapter of
“Operation Overview.”
− “Sine Wave Dynamic” in the chapter of “Local Operation.”
− “Selecting the LAN Type to be Connected”, “Setting Network
Parameter (IP, Subnet Mask, Gateway)”, “Confirming Network
Connection is Successful” and “Communicating with
Instruments” in the chapter of “Remote Operation.”
− Digitizing function.
− 63600-2 Pin Assignments of the System I/O Port Connector.
− 63600-1 Pin Assignments of the System I/O Port Connector.
− Description of SYNCW.
− 63600-1 & 63600-2 mainframe layout dimensions.
− 63610-80-20 & 63640-80-80 outlines.
− 63600-1 mainframe outline.
− 63600-2 specification.
− 63610-80-20, 63630-80-60, 63640-80-80 Constant Impedance
Mode specification.
Modify the followings:
− 63600-1 Input Rating specification.
− 63610-80-20, 63630-80-60, 63640-80-80 specification (Power,
CR Mode range, Voltage read back accuracy, Others & Note
3.)
Correct the following errors:
− CONFigure:ALLRun
− DIGitizing:WAVeform:DATA?
− FETCh:AH?
− FETCh:WH?
− System Bus Port: 8-pin connector to 10-pin connector.
− CE Declaration for model 63600-1, 63600-2 & 63630-600-15.
− Diagram for standard package and accessories list.
−
Specification of new model 63630-600-15.
To Next Page
Loading...
Need help?
General
