− Caution for securing binding post.
− Caution for Timing Measurement Function.
− Definition of minimum drive current for Ext. Wave.
− Configuration list on the panel for factory default.
− “Verification” and “Appendix A” new chapters.
Modify the following:
−
Program sequence flow chart.
Add “MPP Tracker” section in the chapter of “Local Operation.”
Modify the Input Rating specification for model 63600-1, 63600-2
− “User Defined Waveform” section in the chapter of “Local
Operation.”
− Appendix “How to Use 63600 UDW to Download Softpanel.”
Modify the following in the chapter of “Remote Operation”:
− “ADVANCE Subsystem”
− “CONFIGURE Subsystem”
− “FETCH Subsystem”
− “MODE Subsystem”
Update the CE Declaration.
Update the CE Declaration.
Modify “Digitizing Function” section in the chapter of “Operation
Overview.”
Add a Notice in the section of “Remote Sensing Connections.”
Add the contents of “Select the current range” in the section of
“Setting CR Values.”
Modify the syntax description in the sections of “CONFIGURE
Subsystem”, “DIGITIZING Subsystem” and “RESISTANCE
Add specifications and the related information of Model 63601-5 in
the manual.
− Specifications and related information of Model 63640-150-60
in the manual.
− “LVP” related information in the section of “Protection
Features.”
− Operating conditions in CR mode.
Update CE “Declaration of Conformity”.
Update the specification tables in the following sections for “CV
Mode Verification” under the chapter of “Verification”:
− “Checking High Voltage Range”.
− “Checking Medium Voltage Range”.
− “Checking Low Voltage Range”.
Update “Material Contents Declaration” and CE “Declaration of
Conformity”.
Update the accessory list and icon in “Inspection” section.
Add example to “CP Mode Verification” in the chapter of
“Verification”.
Add Ext Wave_Bandwidth to Dynamic CC Mode in “Specifications”
To Next Page
Loading...
Need help?
General
