Chapter 7 Setting Up and Managing User Accounts
Basic User Setup Options
7-6
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Step 5 Under Password Authentication in the User Setup table, select the applicable
authentication type from the list.
Tip The authentication types that appear reflect the databases that you have
configured in the Database Configuration area of the External User
Databases section.
Step 6 Specify a single CiscoSecure PAP password by typing it in the first set of
Password and Confirm Password boxes.
Note Up to 32 characters are allowed each for the Password box and the
Confirm Password box.
Tip The CiscoSecure PAP password is also used for CHAP/MS-CHAP/ARAP
if the Separate CHAP/MS-CHAP/ARAP check box is not selected.
Tip You can configure the AAA client to ask for a PAP password first and
then a CHAP or MS-CHAP password so that when users dial in using a
PAP password, they will authenticate. For example, the following line in
the AAA client configuration file causes the AAA client to enable CHAP
after PAP:
ppp authentication pap chap
Step 7 Do one of the following:
• To finish configuring the user account options and establish the user account,
click Submit.
• To continue to specify the user account options, perform other procedures in
this chapter, as applicable.
To Next Page
Loading...
Need help?
General