Cisco Headset 531 and 532
The Cisco Headset 531 and 532 can be used as standard headsets on the phones. You plug the headset into
the headset port using the RJ connector.
The Cisco Headset USB Adapter is also available for use on the Cisco IP Phone 8851, 8851NR, 8861, 8865,
and 8865NR. The adapter converts the Cisco Headset 531 and 532 into a USB headset, and it gives you a few
extra features. It provides a convenient way to handle calls, to test your microphone, and to customize your
bass and treble, gain, and sidetone settings.
Phone Firmware Release 12.1(1) and later is required for the headsets to function properly.
Figure 3: Cisco Headset 531
Figure 4: Cisco Headset 532
Cisco Headset 561 and 562
Cisco Headset 561 and 562 are two wireless headsets that have been developed for use in today's office. The
Cisco Headset 561 features a single earpiece for extended wear and comfort. Cisco Headset 562 features two
earpieces for use in a noisy workplace.
Both headsets come with either the Standard base or the Multibase for charging your headset, and for monitoring
the headset power level with the LED display. Both bases also displays your call status, such as incoming
call, active call, and calls on mute. If your headset is upgrading the firmware, then the LEDs show the upgrade
progress.
The base connects to the phone using either a USB connector or a Y cable depending upon your phone model
and your personal preference. The Y cable plugs into the AUX and headset ports of the phone.
An AC plug is included for connecting the base to a power outlet. You have to install the power clip for your
region before you can plug in the power adapter.
Cisco IP Phone 7800 and 8800 Series Accessories Guide for Cisco Unified Communications Manager
11
Headsets
Cisco Headset 500 Series
To Next Page
Loading...
Need help?
General
