Place an active call on hold before you change to a different call source. Calls on one call source aren't
automatically put on hold when you switch to a different call source.
Note
Cisco Headset 700 Series
The Cisco Headset 730 is a wireless headset that uses Bluetooth connectivity to pair with Cisco soft clients
and Cisco IP Phones. The headset features full call control and music playback capabilities in addition to
powerful noise cancellation and ambient audio enhancement systems for use in a busy office environment.
The Cisco Headset 730 comes with a USB Bluetooth Adapter for use with devices that don't offer a reliable
Bluetooth solution. The headset can also connect to devices with the included USB-C to USB-A cable. The
USB-C cable also acts as a charging cable and can connect to any powered USB adapter. The USB-C cable
can also be plugged into the phone USB port to give full functionality, including call control, local tuning and
setup, and firmware upgrades.
For more information see: https://www.cisco.com/c/en/us/products/collaboration-endpoints/headset-700-series/
index.html
Cisco Headset 730 Buttons and Hardware
Your headset buttons are used for many features. Each cup has different buttons and functions.
Figure 12: Left and Right Sides of the Cisco Headset 730
Cisco IP Phone 7800 and 8800 Series Accessories Guide for Cisco Unified Communications Manager
20
Headsets
Cisco Headset 700 Series
To Next Page
Loading...
Need help?
General
