Table 17: Cisco Headset 500 Series Parameters for Cisco IP Phone 8800 Series
Description and Usage GuidelinesProduct Specific
Configuration
Parameter
Phone FirmwareCisco Headset
The headset usually requires about 5 seconds to
upgrade.
Side USB Port
Back USB Port
Phone Firmware
Release 12.1(1)
or later
Cisco Headset
521 and 522
The headset usually requires about 5 seconds to
upgrade.
Side USB Port
Back USB Port
Phone Firmware
Release 12.1(1)
or later
Cisco Headset
531 and 532
The headset usually requires 5 to 15 minutes to
upgrade, and the base LEDs light in sequence to show
the upgrade progress. The user can postpone the
upgrade up to 4 times.
If you are using the Y cable to connect the headset
base to the phone, then you must enable Wireless
Headset Hookswitch Control.
If you are using the USB cable to connect the headset
base to the phone, then you must the appropriate USB
port.
Wireless
Headset
Hookswitch
Control
Side USB Port
Back USB Port
Phone Firmware
Release
12.5(1)SR1 or
later, and the
latest device
package
Cisco Headset
561 and 562
Table 18: Cisco Headset 700 Series Parameters for Cisco IP Phone 8800 Series
Description and Usage GuidelinesProduct Specific
Configuration
Parameter
Phone FirmwareCisco Headset
The headset usually requires about 5 seconds to
upgrade.
Side USB Port
Back USB Port
Phone Firmware
Release 12.7(1)
or later
Cisco Headset
730
Related Topics
Accessory Support, on page 1
Set Up a Headset for a Single Phone
You can configure a single phone or a group of phones for headset support. To configure a group of phones,
use the Common Phone Profile.
Procedure
Step 1 Sign into Cisco Unified Communications Manager Administration as an administrator.
Step 2 Select Device > Phone
Step 3 Locate the phone associated with the user.
Cisco IP Phone 7800 and 8800 Series Accessories Guide for Cisco Unified Communications Manager
27
Headsets
Set Up a Headset for a Single Phone
To Next Page
Loading...
Need help?
General
