Cisco 7800 Series Accessories Guide

Cisco Headset 561 and 562 Standard Base
The standard base charges your headset and has LEDs that shows your headset's battery level and call state.
You can also answer and end calls when you lift or place your headset on the base.
The standard base comes with the following connector cables:
• USB to USB Cable: for devices with USB connectivity
• USB Y-Cable: for Cisco IP Phones without a USB port
• USB-A to USB-C Cable: available separately for PC or Mac devices
Figure 10: Standard Base LEDs
The following table describes the standard base
Table 13: Standard Base LEDs
DescriptionNameNumber
Indicates the headset battery charge and base status:
• Headset battery strength—LEDs blink and change to
solid as the battery charges
• Headset update in progress—LEDs blink in sequence,
left to right
• Headset and base not paired—All LEDs blink
• Power save mode—Middle LED shows solid
The base enters power save mode when there is no call source
connectivity after 10 minutes.
Battery Status LED1
Cisco IP Phone 7800 and 8800 Series Accessories Guide for Cisco Unified Communications Manager
17
Headsets
Cisco Headset 561 and 562 Standard Base

Cisco 7800 Series Specifications

General

Wireless	No
Video Support	No
PoE	Yes, 802.3af/at
Audio Codec Support	G.711, G.722, G.729, iLBC
Network Protocols	SIP, SDP, IPv4, IPv6, UDP, TCP, DNS, TFTP, HTTP, HTTPS, DHCP
Security Features	802.1X, TLS, SRTP
Power Options	PoE
Headset Port	3.5mm
Buttons	Line keys, navigation cluster, softkeys, mute, speakerphone, headset, volume control
Bluetooth	No
Ethernet Switch	Yes, 2-port 10/100/1000
USB Port	Yes, for headset (7875)