4-24
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Chapter 4 Using the Cisco Unified Wireless IP Phone 7925G Web Pages
Configuring Network Profiles
Step 3 Click Save to make the change.
Disabling DHCP
To disable the use of DHCP in the Network Profile, follow these steps:
Procedure
Step 1 Choose the network profile that you want to configure.
Step 2 Under the IP Network Configuration area, choose this option:
Use the following IP addresses and DNS servers
Step 3 You must enter these required IP addresses. See Table 4-7 for descriptions of these fields.
Step 4 Click Save to make the change.
Configuring the Alternate TFTP Server
If you use DHCP to direct the Cisco Unified Wireless IP Phone 7925Gs to a TFTP server, you can also
assign an alternative TFTP server to some phones instead of the one assigned by DHCP.
Note If you disable DHCP, then you must use these steps to set up the TFTP server for the phone.
To assign an alternate TFTP server to a phone, follow these steps:
Procedure
Step 1 Choose the network profile that you want to configure.
Step 2 In the TFTP area, choose this option:
Use the following TFTP servers
Ta b l e 4-7 Static IP Addresses When DHCP is Disabled
Static Setting Description
IP Address IP address of the phone
Subnet Mask Subnet mask used by the phone
Default Router 1 Primary gateway used by the phone
DNS Server 1
DNS Server 2
Primary DNS server used by the phone
Optional backup DNS server used by the phone
TFTP Server 1
TFTP Server 2
Primary TFTP server used by the phone
Optional backup TFTP server used by the phone
Domain Name Name of the DNS in which the phone resides
To Next Page
Loading...
Need help?
General
