6-10
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Chapter 6 Configuring the Phone Using the Wavelink Avalanche Server
Updating the Phone
Configuring Wavelink Settings
You can configure Wavelink settings from the phone CU. Table 6-5 describes the Wavelink settings.
Updating the Phone
When you have completed the phone configuration changes, you must export the configuration file from
the phone CU to Wavelink, and then update the phone.
Note The Cisco Unified Wireless IP Phone 7925G CU does not perform a complete validation of the phone
configuration. If the configuration file contains an invalid setting, the phone might reject the
configuration and send an error message to the syslog.
To update the phone with the updated configuration file, perform the following steps.
Procedure
Step 1 From the phone CU, select the configuration file, then choose Export to Wavelink.
Kernel Level Operating System data.
Configuration Level Phone configuration data.
Call Control Level Cisco Unified Communications Manager data.
Network Services Level DHCP, TFTP, CDP data.
Security Level Application level security data.
User Interface Level Key strokes, softkeys, MMI data.
Wireless Level Channel scanning, authentication data.
Audio Level RTP, SRTP, RTCP, DSP data.
System Level Firmware, upgrade data.
Table 6-4 Trace Settings (continued)
Item Description
Ta b l e 6-5 Wavelink Settings
Setting Description
Enable Enables the Wavelink server.
Use Alternate Server Enables the use of alternate Wavelink server.
Alternate Server If the User Alternate Server is enabled, enter an IP address for the
alternate server.
Custom Name 1-4 Assign up to four attribute names to the phone to be used as
selection criteria.
Custom Value 1-4 Define the values for each Custom Name to be used as selection
criteria.
To Next Page
Loading...
Need help?
General
