6-9
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Chapter 6 Configuring the Phone Using the Wavelink Avalanche Server
Updating Configuration Files
Note If you uncheck all channels in the 802.11 G Power Settings or 802.11 A Power Settings, the phone will
not be able to access the WLAN.
Configuring USB Settings
You can change the IP address of the USB port on your phone by choosing one of the following options
in the DHCP Enabled field:
• Yes—Obtains an IP address automatically.
• No—You can specify the IP address and subnet mask on this page.
Note See also Configuring USB Settings, page 4-26.
Configuring Trace Settings
You can configure trace settings to determine how the phone creates and saves trace files. Table 6-4
describes the trace settings.
Antenna Selection for
802.11B
• Vertical
• Horizontal
• Diversity
802.11G Power Settings Enabled—Identifies enabled channels in WLAN to improve
scanning for the phone
Max Tx Power—Sets the maximum transmit power for the
phone
802.11A Power Settings Enabled—Identifies enabled channels in WLAN to improve
scanning for the phone
Max Tx Power—Sets the maximum transmit power for the
phone
Table 6-3 Profile Settings (continued)
Item Description For More Information, See...
Ta b l e 6-4 Trace Settings
Item Description
Number of Files Choose the number of trace files that the phone saves, from 2-10
files.
Enable Remote Syslog Set up a remote server to store trace logs. If enabled, enter remote
address and remote port.
Remote IP Address Enter remote IP address if Enable Remote Syslog is enabled.
Remote Port Enter a port number if Enable Remote Syslog is enabled. Valid
values are: 514 and 1024 to 65535.
To Next Page
Loading...
Need help?
General
