Cisco 7925G - Unified Wireless IP Phone VoIP - Page 140

6-8
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Chapter 6 Configuring the Phone Using the Wavelink Avalanche Server
Updating Configuration Files
Password Assigns the network authentication password for this profile
WPA Pre-shared Key
Credentials
Sets the Pre-shared key for this profile
Pre-shared Key Type Determines the key type: Hex or ASCII
Pre-shared Key Identifies the key
Wireless Encryption
Required for Open+WEP and Shared+WEP authentication methods
WEP Keys Type Determines the encryption key type: Hex or ASCII
WEP Keys TxKey Identifies the Transmit Key.
WEP Key Length 1-4 Determines the WEP key length with key size of 40 or 128 bits.
WEP Key Value 1-4 Defines the WEP key value:
• 40 bits—5 ASCII or 10 Hex characters
• 128 bits—13 ASCII or 26 Hex characters
Network Settings
DHCP Enabled • Yes—Enables DHCP to obtain IP address and DNS servers
automatically.
• No—DHCP is disabled and you will need to enter the
following fields:
– IP Address
– Subnet Mask
– Default Router
– Primary DNS
– Secondary DNS
– Domain Name
TFTP
Alternate TFTP Determines whether DHCP assigns the TFTP server.
If yes, enter static IP addresses for:
• TFTP Server 1
• TFTP Server 2
Advanced WLAN Settings
TSPEC Settings
Minimum PHY Rate Minimum data rate that outbound traffic uses
Surplus Bandwidth Excess bandwidth beyond application requirements
Antenna Settings
Antenna Selection for
802.11A
• Vertical
• Horizontal
• Diversity
Table 6-3 Profile Settings (continued)
Item Description For More Information, See...