6-6
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Chapter 6 Configuring the Phone Using the Wavelink Avalanche Server
Updating Configuration Files
To update settings in the phone configuration file, follow these steps:
Procedure
Step 1 Right click 7925CU (in a folder under Software Collections) to launch the CU.
Step 2 From the left pane, choose the settings you wish to configure: Profile Settings, USB Settings, Trace
Settings, or Wavelink Settings.
Step 3 From the settings page, select or enter information for those settings.
Step 4 Click Apply.
Configuring Profile Settings
Table 6-3 lists the profile settings.
Note See also Network Profile Settings, page 4-8, in the Using the Cisco Unified Wireless IP Phone 7925G
Web Pages chapter.
USB Settings Configuring USB Settings, page 6-9
Trace Settings Configuring Trace Settings, page 6-9
Wavelink Settings Configuring Wavelink Settings, page 6-10
Table 6-2 Configuration File Settings
Setting For more information, see...
Ta b l e 6-3 Profile Settings
Item Description For More Information, See...
Profile Name Provides a name for the profile to make it easy to identify; up
to 63 alphanumeric characters.
Profile Enabled Choose Yes or No.
WLAN Settings
SSID Assigns the Service Set Identifier (SSID) to this profile. You
must assign the same SSID to the phone that is also assigned to
access points in the wireless network.
To Next Page
Loading...
