CHAPTER
9-1
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
9
Monitoring the Cisco Unified Wireless IP Phone
Remotely
This chapter describes the methods for monitoring the Cisco Unified Wireless IP Phone 7925G by using
a web page. It contains the following sections:
• Accessing the Web Page for a Phone, page 9-1
• Summary Information, page 9-2
• Network Configuration Information, page 9-3
• Device Information, page 9-6
• Wireless LAN Statistics, page 9-7
• Wireless LAN Statistics, page 9-7
• Stream Statistics, page 9-10
For information about using these web pages, see Chapter 4, “Using the Cisco Unified Wireless IP
Phone 7925G Web Pages.” For more information about troubleshooting the Cisco Unified IP Phone,
Chapter 10, “Troubleshooting the Cisco Unified Wireless IP Phone 7925G.”
Accessing the Web Page for a Phone
To access the web page for a Cisco Unified Wireless IP Phone 7925G, perform the following steps.
Procedure
Step 1 Obtain the IP address of the Cisco Unified Wireless IP Phone 7925G using one of these methods:
• Search for the phone in Cisco Unified Communications Manager by choosing Devices > Phones.
Phones registered with Cisco
Unified Communications Manager display the IP address on the Find
and List Phones web page and at the top of the Phone Configuration web page.
• On the Cisco Unified Wireless IP Phone 7925G, press SETTINGS > Device Information>
Network and then scroll to the IP Address option.
Step 2 Open a web browser and enter the following URL, where IP_address is the IP address of the
Cisco
Unified IP Phone:
https://<IP_address>
To Next Page
Loading...
Need help?
General
