CHAPTER
6-1
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
6
Configuring the Phone Using the Wavelink
Avalanche Server
This chapter describes the Wavelink Avalanche Management Console and how to use it to configure the
Cisco
Unified Wireless IP Phone 7925G. The Cisco Unified Wireless IP Phone 7925G Configuration
Utility (CU) can be installed on the Wavelink Avalanche Management Console and used to configure a
single phone or multiple phones with common settings.
This chapter contains the following sections:
• Before You Begin, page 6-1
• Best Practices, page 6-2
• Assigning the Wavelink Server, page 6-2
• Setting Up and Using the Phone CU, page 6-3
Note There is no support for Traffic Stream Rate Set (TSRS) or Cisco Compatible Extensions (CCX) V4.
Note There are limitations using Wavelink because not all features are configurable. Some features are
configurable only by using Cisco Unified Communications Manager Administration.
Before You Begin
Before you can use the Wavelink Avalanche Management Console to configure phones, ensure that you
have the necessary components and follow the best practices during your setup.
The following components are required for configuring the phone using the Wavelink Avalanche server:
• Wavelink Avalanche software
–
Avalanche Manager Agent
–
Avalanche Management Console
• Cisco Unified Wireless IP Phone 7925G firmware release 1.1
• Cisco Unified Wireless IP Phone 7925G CU Avalanche Application Package
• DHCP server (optional)
• Cisco Unified Communications Manager (optional)
To Next Page
Loading...
Need help?
General
