6-3
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Chapter 6 Configuring the Phone Using the Wavelink Avalanche Server
Setting Up and Using the Phone CU
Assigning the Wavelink Server using the Phone Web Page
To assign the Wavelink server using the phone web page, follow these steps:
Procedure
Step 1 From the phone web page, choose Wavelink Settings from the left pane.
Under Wavelink Settings, make sure that the server is enabled.
Step 2 Click Use the following Server and enter the IP address of the server, then click Save.
Setting Up and Using the Phone CU
This section describes the tasks for configuring and using the Cisco Unified Wireless IP Phone 7925G
CU from the Wavelink Management Console.
Note Be aware that the Cisco Unified Wireless IP Phone 7925G CU is labeled as 7921G but the CU works for
both phones.
To set up and use the Cisco Unified Wireless IP Phone 7925G CU from the Wavelink Management
Console, perform the tasks in
Table 6-1 in order.
Assigning Attributes for the Phone
You can assign attributes on the Cisco Unified Wireless IP Phone 7925G that can be used to distinguish
it from other mobile devices connected to the Wavelink server. These attributes can be used as search
criteria for locating phones on the Wavelink server. For example, the predefined ModelName field of
CP7925G is used to identify a device as the Cisco
Unified Wireless IP Phone 7925G.
To assign attributes, use the Wavelink Management Console, the phone UI, or the phone web page:
• If you use the Wavelink Management Console, choose the Add Properties option from the Client
Settings option (for a single phone) or the Edit Device Properties option (for a mobile device group).
For more information, see the Wavelink Avalanche server documentation.
• If you assign attributes from the phone or phone web page, you define values for the CustomName
and CustomValue fields:
Ta b l e 6-1 Setting Up and Using the Phone CU on the Wavelink Console
Task For more information, see...
1. Assign attributes for the phone. Assigning Attributes for the Phone, page 6-3
2. Install the Cisco Unified Wireless IP Phone7925G CU on
Wavelink.
Setting Up and Using the Phone CU, page 6-3
3. Update the configuration files. Updating Configuration Files, page 6-5
4. Update the phones. Assigning Attributes for the Phone, page 6-3
To Next Page
Loading...
Need help?
General
