Cisco 7925G - Unified Wireless IP Phone VoIP - Changing Phone Settings

5-10
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Chapter 5 Configuring Settings on the Cisco Unified Wireless IP Phone 7925G
Changing Phone Settings
Related Topics
• Accessing Network and Phone Settings, page 5-1
• Configuring Network Profile Settings, page 5-2
• Configuring the Security Certificate on the Phone, page 5-12
• Changing Phone Settings, page 5-10
Changing Phone Settings
The Phone Settings menu enables configuration of individual phones with ring tones or volume levels,
display settings, keypad settings, and home page settings.
Note You can control whether a Cisco Unified Wireless IP Phone 7925G has access to the Phone Settings
menu from the Cisco Unified
Communications Manager Administration Phone Configuration page. Use
the Settings Access field in the Product Specific Configuration section of the phone configuration page.
For more information, see the
“Specific Configuration Options for the Cisco Unified Wireless
IP Phone 7925G” section on page 7-13.
Password Password for the wireless network (up to 32 characters) Configuring the Username and
Password, page 4-15
802.11 Mode The wireless signal standard used in the WLAN. Options
are:
• 802.11b/g
• 802.11a
• Auto-b/g
• Auto-a
• Auto-RSSI
802.11 Standards for WLAN
Communications, page 2-3
Call Power Save Mode The type of power saving mode used in the WLAN.
Options are:
• U-APSD/PS-Poll
• None
Networking Protocols Used with
Cisco Unified Wireless IP Phones,
page 2-9
Scan Mode Auto—Scans when on a call or when the strength signal
(RSSI) is low.
Continuous—Scans continuously even when it is not in
a call.
Single AP—Never scans except when the basic service
set (BSS) is lost.
Wireless Network Requirements
for VoIP, page 2-21
Table 5-3 WLAN Configuration Settings (continued)
Network Setting Description For More Information, See...