Cisco 7925G - Unified Wireless IP Phone VoIP - Adding Phones with BAT; Adding Phones with Cisco Unified Communications Manager Administration

3-4
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Chapter 3 Setting Up the Cisco Unified Wireless IP Phone 7925G
Before You Begin
Adding Phones with BAT
Add a group of phones to the Cisco Unified Communications Manager database by using BAT. This tool
performs batch operations, including registration, on multiple phones. You need the MAC addresses for
each phone before you use BAT.
Table 3-2 describes how to determine the MAC address of the wireless IP phone.
Note BAT is included in Cisco Unified Communications Manager 5.0 or later, but it is a plug-in for prior
releases.
For detailed instructions about using BAT, refer to the following documents:
• For Cisco Unified Communications Manager Release 5.0 and prior releases, refer to Bulk
Administration Tool User Guide for Cisco Unified
Communications Manager.
• For Cisco Unified Communications Manager Release 6.0(1), 6.1(1), and 7.0(1), refer to Cisco
Unified Communications Manager Bulk Administration Guide.
Note When using BAT to add Cisco Unified Wireless IP Phones, use the default setting for the phone load.
The phone load name includes symbols (-, _,.) and BAT does not permit symbols in an entry.
Related Topics
• Adding Phones with Auto-Registration, page 3-3
• Adding Phones with Auto-Registration and TAPS, page 3-3
• Adding Phones with Cisco Unified Communications Manager Administration, page 3-4
Adding Phones with Cisco Unified Communications Manager Administration
Add phones individually by using Cisco Unified Communications Manager Administration. To do so,
obtain the MAC address for each phone before you begin. See the
“Methods for Adding Phones to Cisco
Unified Communications Manager” section on page 3-2 for instructions.
Perform one of the following after collecting the MAC addresses:
• Cisco Unified Communications Manager 5.0, 6.0(1), 6.1(1), or 7.0(1)—Choose Device > Phone and
click Add New.
• Cisco Unified Communications Manager 4.x—Choose Device > Add a New Device.
Ta b l e 3-2 Determining the MAC Address of the Phone
Method For More Information
Choose SETTINGS > Model Information >
MAC Address and look at the MAC Address
field.
See “Viewing Model Information” section on
page 8-7
Remove the battery and look on the back of the
phone.
See the “Installing or Removing the Phone
Battery” section on page 3-8