6-7
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Chapter 6 Configuring the Phone Using the Wavelink Avalanche Server
Updating Configuration Files
WLAN Mode Determines the signal mode or priority for selecting signal
modes available in the WLAN. Options are:
• 802.11 b/g—Use only 2.4 GHz band
• 802.11a—Use only 5 GHz band
• Auto, 802.11b/g preferred over 802.11a (dual band)
• Auto, 802.11a preferred over 802.11b/g (dual band)
Note The preferred band, if available, will be used at
power-on, but the phone may switch to the less
preferred 2.4 GHz band, if available, and the preferred
band is lost. Once the phone has connected to the less
preferred band, it will not scan for the preferred band if
the current band is acceptable, and may remain
connected to the less preferred band.
• Auto, signal strength (RSSI)—Use strongest signal in dual
band environment
802.11 Standards for WLAN
Communications, page 2-3
Call Power Save Mode Set for the type of power saving mode used in the WLAN.
Options are:
• U-APSD/PS-Poll
• None
802.11 Standards for WLAN
Communications, page 2-3
WLAN Security
Authentication Mode Sets the authentication and encryption methods for this profile:
• Open—Open access to APs
• Open+WEP—Open access with WEP encryption (requires
an encryption key)
• Shared+WEP—Shared key authentication with WEP
(requires an encryption key)
• LEAP—Cisco proprietary authentication and encryption
using a RADIUS server (requires a username and
password)
• EAP-FAST—Authentication and encryption using TLS
and RADIUS server (requires a username and password)
• Auto (AKM)—Automatic authenticated key management
using:
–
WPA, WPA2 (requires a username and password)
–
WPA-Pre-shared key, WPA2-Pre-shared key (requires
a passphrase/pre-shared key)
–
CCKM (requires a username and password)
Wireless Security
Credentials
Required for LEAP, EAP-FAST, and Auto (AKM) authentication methods
Username Assigns the network authentication username for this profile
Table 6-3 Profile Settings (continued)
Item Description For More Information, See...
To Next Page
Loading...
