EasyManuals Logo

Cisco 7925G - Unified Wireless IP Phone VoIP User Manual

Cisco 7925G - Unified Wireless IP Phone VoIP
244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #123 background imageLoading...
Page #123 background image
5-5
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Chapter 5 Configuring Settings on the Cisco Unified Wireless IP Phone 7925G
Configuring Network Profile Settings
Host Name Unique host name that the DHCP server assigned to
the phone
Display only, cannot configure
DHCP Enabled Yes—Allows the Dynamic Host Configuration
Protocol (DHCP) to obtain an IP address for the
phone
No—Disables the use of DHCP. You must
configure the static settings for the phone
Configuring DHCP Settings,
page 5-6
IP Address Internet Protocol (IP) address of the phone Configuring DHCP Settings,
page 5-6
Subnet Mask Subnet mask used by the phone
Default Router 1 Primary gateway used by the phone
Domain Name Name of the Domain Name System (DNS) domain
in which the phone resides
DNS Server 1 Primary DNS server used by the phone
DNS Server 2 Optional backup DNS server used by the phone
Alternate TFTP Yes—This option assigns an alternative Trivial File
Transfer Protocol (TFTP) server
No—This option uses the TFTP server assigned by
DHCP
Configuring an Alternate TFTP
Server, page 5-7
TFTP Server 1 IP address for the primary TFTP server used by the
phone. If you set Alternate TFTP option to Yes, you
must enter a non-zero value for this option
TFTP Server 2 Optional backup TFTP server the phone uses if the
primary TFTP server is not available
Load Server IP address for the server where the phone receives
firmware updates
Cisco Unified Communications
Manager Administration Guide.
CDP Enabled Enables or disables Cisco Discovery Protocol
(CDP) for the phone in Cisco Unified
Communications Manager Administration
Changing the Cisco Discovery
Protocol Settings, page 5-7
Cisco Unified Communications
Manager Administration Guide.
Erase Configuration Deletes the phone configuration and sets to factory
defaults
Handset Only Mode Yes—Indicates that the speakerphone is disabled on
the phone
No—Indicates that the speakerphone is enabled on
the phone
Specific Configuration Options for
the Cisco Unified Wireless
IP Phone 7925G, page 7-13
Table 5-1 Network Configuration Settings (continued)
Network Setting Description For More Information, See...

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7925G - Unified Wireless IP Phone VoIP and is the answer not in the manual?

Cisco 7925G - Unified Wireless IP Phone VoIP Specifications

General IconGeneral
Wireless802.11a/b/g
ProtocolsSIP, SCCP
Headset Jack2.5 mm
SpeakerphoneYes
Battery TypeLithium-ion
CompatibilityCisco Unified Communications Manager
Display2 inch color display
SecurityWPA, WPA2
BatteryLithium-ion battery
Voice CodecsG.711a, G.711u, G.729a
Operating Temperature32 to 104°F (0 to 40°C)

Related product manuals