Cisco IE 3000 - Page 736

Index
IN-14
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
IGMP profile
applying 21-25
configuration mode 21-24
configuring 21-24
IGMP snooping
and address aliasing 21-2
configuring 21-6
default configuration 21-6
definition 21-1
enabling and disabling 21-7
global configuration 21-7
Immediate Leave 21-5
method 21-8
monitoring 21-15
querier
configuration guidelines 21-13
configuring 21-13
supported versions 21-2
support for 1-3
VLAN configuration 21-7
IGMP throttling
configuring 21-26
default configuration 21-24
described 21-23
displaying action 21-28
Immediate Leave, IGMP 21-5
inaccessible authentication bypass 10-13
initial configuration
defaults 1-10
Express Setup 1-2
interface
range macros 11-8
interface command 11-5 to 11-6
interface configuration mode 2-3
interfaces
auto-MDIX, configuring 11-16
configuration guidelines
duplex and speed 11-13
interfaces (continued)
configuring
procedure 11-6
counters, clearing 11-20
default configuration 11-10
described 11-17
descriptive name, adding 11-17
displaying information about 11-19
flow control 11-15
management 1-4
monitoring 11-19
naming 11-17
physical, identifying 11-5
range of 11-6
restarting 11-20
shutting down 11-20
speed and duplex, configuring 11-14
status 11-19
supported 11-4
types of 11-1
interfaces range macro command 11-8
interface types 11-5
Intrusion Detection System
See IDS appliances
inventory management TLV 23-2, 23-6
IP ACLs
for QoS classification 32-6
implicit deny 30-7, 30-11
implicit masks 30-7
named 30-12
undefined 30-17
IP addresses
candidate or member 6-3, 6-12
cluster access 6-2
command switch 6-3, 6-10, 6-12
discovering 7-26
redundant clusters 6-10
standby command switch 6-10, 6-12
See also IP information