Cisco IE 3000 - Page 737

Index
IN-15
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
ip igmp profile command 21-24
IP information
assigned
manually 4-14
through DHCP-based autoconfiguration 4-3
default configuration 4-3
IP phones
and QoS 15-1
automatic classification and queueing 32-18
configuring 15-4
ensuring port security with QoS 32-34
trusted boundary for QoS 32-34
IP precedence 32-2
IP-precedence-to-DSCP map for QoS 32-51
IP protocols in ACLs 30-9
IP Service Level Agreements
See IP SLAs
IP service levels, analyzing 31-1
IP SLAs
benefits 31-2
configuration guidelines 31-5
Control Protocol 31-4
default configuration 31-5
definition 31-1
measuring network performance 31-2
monitoring 31-6
operation 31-3
responder
described 31-4
enabling 31-6
response time 31-4
SNMP support 31-2
supported metrics 31-2
IP traceroute
executing 34-12
overview 34-11
IPv4 ACLs
applying to interfaces 30-16
extended, creating 30-8
named 30-12
standard, creating 30-7
J
join messages, IGMP 21-3
L
LACP
See EtherChannel
Layer 2 frames, classification with CoS 32-2
Layer 2 interfaces, default configuration 11-10
Layer 2 traceroute
and ARP 34-11
and CDP 34-10
broadcast traffic 34-10
described 34-10
IP addresses and subnets 34-11
MAC addresses and VLANs 34-11
multicast traffic 34-11
multiple devices on a port 34-11
unicast traffic 34-10
usage guidelines 34-10
Layer 3 packets, classification methods 32-2
LDAP 5-2
Leaking IGMP Reports 19-4
LEDs, switch
See hardware installation guide
lightweight directory access protocol
See LDAP
line configuration mode 2-3
Link Aggregation Control Protocol
See EtherChannel
link failure, detecting unidirectional 17-7