Cisco WAP2000 - Using a Poe Router or Switch to Connect the WAP2000; Using a Standard Router or Switch to Connect the WAP2000

Installing the WAP2000 Access Point
Connecting the Equipment
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide 11
4
Using a PoE Router or Switch to Connect the WAP2000
To connect the WAP2000 to your network using a PoE router or switch, use the
supplied Ethernet cable to connect the Ethernet port of the access point to a PoE
port on the PoE router or switch.
The LEDs on the front panel light up as soon as the WAP2000 powers on.
Using a Standard Router or Switch to Connect the WAP2000
To connect the WAP2000 to your network using a standard switch, follow these
steps.
STEP 1 Use the supplied Ethernet cable to connect the Ethernet port of the access point
to an Ethernet port on the router or switch.
STEP 2 Connect the included power adapter to the Power port of the WAP2000.
STEP 3 Plug the power adapter into an electrical outlet.