6
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide 17
Configuring the WAP2000 Access Point
This chapter describes how to configure your Cisco WAP2000 Wireless-G
Access Point with Power Over Ethernet using the web-based configuration utility.
Configuration is not required if you wish to use the access point right out of the
box with its default settings.
This chapter includes the following sections:
• Setting Up Your Access Point, page18
• Configuring Wireless Settings, page 22
• Configuring the Access Point’s Modes of Operation, page 48
• Configuring Administration Settings, page 51
• Verifying Access Point Status, page 61
• Using Windows Help Menus, page 66
To Next Page
