Configuring the WAP2000 Access Point
Configuring Wireless Settings
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide 22
6
STEP 3 To automatically configure the time settings so that the access point obtains the
time from a public time server:
a. Click NTP.
b. Select a time zone from the Time Zone drop-down menu.
c. If you are using the access point in a location that observes daylight saving
time, check the Automatically adjust clock for daylight saving changes
check box.
d. To use a local NTP server, click Enabled. The default is Disabled.
In the NTP Server IP field, enter the IP address of your NTP Server.
STEP 4 Click Save.
Configuring Wireless Settings
This section describes how to configure the wireless settings of the access point:
• Configuring Basic Settings, page 23
• Configuring Security, page 25
• Configuring Connection Control, page 41
• Configuring Advanced Settings, page 43
• Configuring VLAN & QoS, page 46
To Next Page
Loading...
