Cisco WAP2000 - Configuring WPA-Personal

Configuring the WAP2000 Access Point
Configuring Wireless Settings
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide 27
6
Configuring WPA-Personal
WPA stands for Wi-Fi Protected Access, which is a security standard stronger than
WEP encryption and forward compatible with IEEE 802.11i.
To configure the WPA-Personal (also known as WPA-PSK) wireless security
settings for the access point, follow these steps:
STEP 1 Click Wireless > Security.
STEP 2 From the Security Mode drop-down menu, select WPA-Personal.
STEP 3 To enable wireless isolation across SSIDs, select Enabled from the drop-down
menu. Otherwise, select Disabled.
STEP 4 To enable wireless isolation within SSID, select Enabled from the drop-down
menu. Otherwise, select Disabled.