Cisco WAP2000 - Checking Wireless Status

Configuring the WAP2000 Access Point
Verifying Access Point Status
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide 63
6
Checking Wireless Status
The Status > Wireless window displays the access point’s current status
information for the wireless networks.
To check the wireless network status of the access point, follow these steps:
STEP 1 Click Status > Wireless.
This page displays the status of the wireless network:
• MAC Address—The MAC address of the access point’s wireless interface.
• Mode—The access point’s wireless network mode.
• Channel—The access point’s channel setting for the SSID.
• Bandwidth Utilization—The percentage of the bandwidth being used.
• VLAN Trunk—The VLAN Trunk status.
• Priority Setting—The priority setting status.
• SSID 1–4—Information about the access point’s configured SSIDs.