Cisco WAP2000 - Configuring WPA2-Enterprise Mixed

Configuring the WAP2000 Access Point
Configuring Wireless Settings
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide 35
6
Configuring WPA2-Enterprise Mixed
This security mode supports the transition from WPA-Enterprise to WPA2-
Enterprise.
You can have client devices that use either WPA-Enterprise or WPA2-Enterprise.
The access point automatically chooses the encryption algorithm used by each
client device.
To configure the WPA2-Enterprise Mixed wireless security settings for the access
point, follow these steps:
STEP 1 Click Wireless > Security.
STEP 2 From the Security Mode drop-down menu, select WPA2-Enterprise Mixed.
STEP 3 To enable wireless isolation across SSIDs, select Enabled from the drop-down
menu. Otherwise, select Disabled.
STEP 4 To enable wireless isolation within SSID, select Enabled from the drop-down
menu. Otherwise, select Disabled.