Getting Started
Navigating the Web-Based Utility
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide 15
5
Setup
This window allows you to configure the host name and IP address settings and to
set the time through the following windows:
• Basic Setup—Configures the Host Name and IP Address settings for this
access point.
• Time—Sets the time either manually, or automatically from a time server if
the access point can access the public internet.
Wireless
This window allows you to enter a variety of wireless settings for the access point.
• Basic Settings—Chooses the wireless network mode (for example,
wireless-G), wireless channel, and SSID configuration on this window.
• Security—Configures the access point’s security settings including access
authentication, data encryption, and wireless isolation.
• Connection Control—Populates your access list to permit or block specific
MAC addresses from accessing your wireless network.
• Advanced Settings—Configures the access point’s more advanced
wireless settings such as beacon interval and output power.
• VLAN & QoS—Configures the VLAN and QoS related settings for the
access point.
AP Mode
This window allows you to configure the access point operation mode with the
Wireless Distribution System (WDS).
Administration
This window allows you to manage the access point.
• Management—Configures the password and Simple Network
Management Protocol (SNMP) settings.
• Log—Configures the log settings for the access point.
• Factory Default—Resets the access point to its factory default settings.
To Next Page
Loading...
