Configuring the WAP2000 Access Point
Configuring Wireless Settings
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide 39
6
Configuring WEP
CAUTION For improved security, migrate to WPA or WPA2. The Wired Equivalent Privacy
(WEP) security mode is not recommended any more, due to its weak security
protection. It was defined in the original IEEE 802.11 specification.
To configure the WEP wireless security settings for the access point, follow these
steps:
STEP 1 Click Wireless > Security.
STEP 2 From the Security Mode drop-down menu, select WEP.
To Next Page
Loading...
