Installing the WAP2000 Access Point
Verifying the Hardware Installation
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide 12
4
The LEDs on the front panel light up as soon as the WAP2000 powers on.
Verifying the Hardware Installation
To verify the hardware installation, complete the following tasks:
• Check the cable connections.
• Check the LED states, as described in Chapter 3, “Product Overview.”.
NOTE If you need help resolving a problem, visit the Cisco Small Business Support
Community at www.cisco.com/go/smallbizsupport. For technical documentation
and other links, see Appendix D, “Where to Go From Here.”
To Next Page
Loading...
