Configuring the WAP2000 Access Point
Configuring Wireless Settings
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide 45
6
power-saving sleep mode. Higher settings allow your computer to enter
sleep mode, thus saving power, but interferes with wireless transmissions.
The default is 1 ms.
• RTS Threshold—This setting determines how large a packet can be before
the access point coordinates transmission and reception to ensure efficient
communication. This value should remain at its default setting of 2347. If you
encounter inconsistent data flow, only minor modifications are
recommended.
• Fragmentation Threshold—This specifies the maximum size a data packet
can be before splitting and creating a new packet. It should remain at its
default setting of 2346.
A smaller setting means smaller packets, which creates more packets for
each transmission. If you experience high packet error rates, you can
decrease this value, but it likely decreases overall network performance.
Only minor modifications of this value are recommended.
STEP 3 Click Save.
To Next Page
Loading...
