Configuring the WAP2000 Access Point
Configuring the Access Point’s Modes of Operation
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide 49
6
You may wish to change the access point’s mode of operation if you want to use
the access point as a wireless repeater to extend the range of your wireless
network. When set to the Wireless Repeater mode, the wireless repeater is able
to talk to a remote access point within its range and retransmit its signal.
You may alternately wish to change the access point’s mode of operation if you
want to use the access point as a wireless bridge; for example, you can use two
access points in the Wireless Bridge mode to connect two wired networks that
are in two different buildings.
For the Wireless Repeater and Wireless Bridge modes, the Wireless Network
mode, Channel, and Security settings must be the same for other remote wireless
access points and devices.
To Next Page
Loading...
Need help?
General
