Cisco WAP2000 Administration Guide

Configuring the WAP2000 Access Point
Configuring Administration Settings
Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide 54
6
- Get Community—Enter the password that allows read-only access to
the access point’s SNMP information. The default is public.
- Set Community—Enter the password that allows read/write access to
the access point’s SNMP information.The default is private.
- SNMP Trap-Community—Enter the password required by the remote
host computer that receives trap messages or notices sent by the
access point.
- SNMP Trusted Host—Enter the IP address of the host trusted with
accessing the access point’s SNMP information. If this field is set to
0.0.0.0, then access point will response to SNMP message from every
host within the LAN.
- SNMP Trap-Destination—Enter the IP address of the host trusted with
accessing the access point’s SNMP information. If this field is set to
0.0.0.0, then access point will response to SNMP message from every
host within the LAN.
STEP 3 Click Save.

Cisco WAP2000 Specifications

General

Brand	Cisco
Model	WAP2000
Category	Wireless Access Point
Language	English