Chapter 2 Operating Principles
2-3. Operation Panel
2-37 CL-S400DT
[Print sample]
Machine Information
Model Number : CL-S400DT
Boot Version : ****
ROM Version : ********
ROM Date (DD//MM//YY) : **/**/**
ROM Check Sum : ****
FPGA Version : ****.****
Head Check : OK
Print Counter : 0000.082km
Service Counter : 0000.082km
Cut Counter : 0
Sensor Monitor : 1.50V
Option Interface : None
Factory Mode Settings
Through Sensor Positon : 0 dot
Reflect Sensor Position : 0 dot
Machine Tear Position : 0 dot
Machine Cut Position : 0 dot
Machine Peel Position : 0 dot
Machine Horizontal Pos. : 8 dot
AutoCal Mode : On
See Through Sensor : 0.0 V
Reflect Sensor : 0.0 V
SeeThrough Sensitivity : Low
Reflect Sensitivity : Low
Through Cal Level : 2.30 V
Reflect Cal Level : 2.10 V
SensNone Cal Level : 2.05 V
Darkness Rate : High
Double Heat Menu : Off
PowerOn Head Check : On
Head Check Start Pos. : Dot 1
Head Check Stop Pos. : Dot 848
Head Error Print : No
Max Page Length : 32 inch
Void to TOF : Off
Reverse Media Length : 0.00 inch
Min Cut Length : Default
Paper End Sensor : On
Paper End Length : Default
Parallel Error Output : On
Auto Online : Off
Auto Online Delay : 2 sec
Top Form Sensing : On
USB Serial Number : Off
Auto Exec Print : On
Config Print Layout : Standard
Head Clean Message : Off
Print Preference : Darkness
Note:
Citizen continually enhances its
printers with new options and
settings based on our customer’s
requests. Extra or changed menu
items may appear on the print out
in some cases.
Submenus for maintenance only
To Next Page
Loading...
