Chapter 3 Disassembly and Maintenance
3-6 Disassembly, Reassembly and Lubrication
3-23 CL-S400DT
SA2 Head
BH (N), M3x6 (NI)
Bosses
3-6-12. SA2 Head
* The “SA2 Head” can be detached separately without disassembling the printer.
For details, refer to “
3-5-1 SA2 Head”.
When detaching or reinstalling the "SA2 Head", be careful not to
damage the thermal elements. Especially, avoid contacting the
thermal elements with the metal part, etc.
NOTE: Do not touch the thermal elements of the “SA2 Head” with your bare hand.
1. Remove the “SA Cover”. Refer to “
3-6-2 SA Cover and SA LCD PCB”.
2. Remove the “Case” from the main body. Refer to “
3-6-3 Case”.
3. Disconnect the “SA Mechanism Frame” from the “SA2 Base Frame”. Refer to “
3-6-4
Disconnecting “SA Mechanism Frame” from “SA2 Base Frame””.
4. Disassemble the “SA Mechanism Frame”. Refer to “
3-6-7 Disassembly of “SA Mechanism
Frame””.
5. Remove 1 screw (BH (N), M3x6 (NI)) and
detach the “SA2 Head”.
6. There are 2 types of “SA, Head”. When replacing it, read the letters printed on it to identify the
type. Use the type.
Letters to identify the type Parts name
XX-XXXXX XXX EBZ SA2 Head
XX-XXXXX XXX DBE SA2 Head (DP)
Note on reassembling:
• When assembling the “SA2 Head”, align the 2 holes of the “SA2 Head” with the bosses to
engage the “SA2 Head” with the “SA2 Cover Frame”.
Caution
SA2 Head
SA2 Head
XX-XXXXX XXX EBZ
SA2 Head
SA2 Head (DP)
XX-XXXXX XXX EBZ
XX-XXXXX XXX DBE
To Next Page
Loading...
