Chapter 3 Disassembly and Maintenance
3-6 Disassembly, Reassembly and Lubrication
CL-S400DT 3-20
3-6-10. Knob Cover Open and Frames
1. Remove the “SA Cover”. Refer to “3-6-2 SA Cover and SA LCD PCB”.
2. Remove the “Case” from the main body. Refer to “
3-6-3 Case”.
* You can directly access to Steps 6 to 8 after removing the “Case”.
3. Disconnect the “SA Mechanism Frame” from the “SA2 Base Frame”. Refer to “
3-6-4
Disconnecting “SA Mechanism Frame” from “SA2 Base Frame””.
4. Disassemble the “SA Mechanism Frame”. Refer to “
3-6-7 Disassembly of “SA Mechanism
Frame””.
5. Remove the “SA Guide Paper L”. Refer to Step 5 in “
3-6-9 SA Adjust Sensor L”.
6. Disengage 1 “E-Ring, 4”, remove the “Spring Cover Open Knob” and then detach the “Knob
Cover Open”.
7. Remove the “Spring Cover Lock Lever” and pull out the “Lever R Cover Lock” after turning it
fully clockwise as shown in the enlarged view.
* By turning it fully clockwise, its end comes off the frame.
8. Remove the “Lever Support Cover Open”.
9. Remove 1 screw (BH (N), M3x6 (NI)) and detach the “Cover Adjust Sensor L”.
10. Remove 2 screws (BH (N), M3x6 (NI)) and detach the “Plate Peel Guide”. Then, remove 1
screw (NO.0, PHT (PT, BK), M2x5) and detach the “Guide Paper F” from the “Plate Peel
Guide”.
11. Remove 3 screws (BH (N), M3x6 (NI)) and detach the “Frame Front” and the “SA Hinge
Frame” from the “SA Main Frame”.
Plate Peel Guide
SA Hinge Frame
Guide Paper F
Spring Cover Open Knob
Spring Cover
Lock Lever
Lever R Cover Lock
E-Ring, 4
Frame Front
SA Main Frame
BH (N), M3x6 (NI)
Cover Adjust Sensor L
Lever Support Cover Open
Knob Cover Open
BH (N), M3x6 (NI)
BH (N), M3x6 (NI)
BH (N), M3x6 (NI)
NO.0, PHT (PT, BK), M2x5
Lever R Cover Lock
BH (N), M3x6 (NI)
To Next Page
Loading...
